Contents
Introduction
If you have a framed shower door, you might have noticed that the seal strip that runs along the bottom of the door has started to wear out or become damaged. This can lead to water leaking out of the shower and causing damage to your bathroom floor. In this article, we will show you how to replace the framed shower door seal strip to prevent any water damage.
Step 1: Measure the Seal Strip
Before you start replacing the seal strip, you need to measure the length of the old strip. Use a tape measure to measure the length of the strip starting from one end of the shower door to the other. Make sure to write down the measurement so that you can purchase the correct size.
Step 2: Purchase the New Seal Strip
Once you have measured the old seal strip, it is time to purchase a new one. You can find shower door seal strips at most home improvement stores. Make sure to purchase the correct size that matches the measurement you took in step 1.
Step 3: Remove the Old Seal Strip
To remove the old seal strip, use a flathead screwdriver to gently pry it off the shower door. Be careful not to damage the shower door or the surrounding tiles. If there is any remaining adhesive, use rubbing alcohol to remove it.
Step 4: Clean the Shower Door
Before installing the new seal strip, make sure to clean the shower door thoroughly. Use a mild detergent and warm water to clean any dirt or grime that may have accumulated on the door.
Step 5: Install the New Seal Strip
To install the new seal strip, start at one end of the shower door and gently press it into place. Make sure to align the strip with the bottom of the shower door. Continue pressing the strip into place until you reach the other end of the door.
Step 6: Trim the Excess Strip
After installing the new seal strip, you might notice that it is longer than the length of the shower door. Use a pair of scissors to trim the excess strip to match the length of the shower door.
Step 7: Test the Seal
To make sure the new seal strip is working properly, turn on the shower and let it run for a few minutes. Check for any leaks or water seeping out of the shower door. If there are no leaks, then the new seal strip is working correctly.
Step 8: Clean Up
After completing the installation, make sure to clean up any debris or adhesive residue. Throw away the old seal strip and any other trash.
Conclusion
Replacing the framed shower door seal strip is a relatively simple process that can prevent water damage to your bathroom floor. By following these steps, you can replace the seal strip yourself and save money on hiring a professional. Remember to measure the old strip, purchase the correct size, remove the old strip, clean the door, install the new strip, and test the seal.