Awasome How To Cut Deer Skull For Mount Ideas

Put Your Knee On The Deer’s Neck, And Rotate The Skull Around By The Antlers (Or, If You’re Removing A Doe Skull For Some Reason, By The Top Of The Head).

But i doubt you will have to bang on it as it will. Once a cut has been made from the nose to the head, slowly start to peel the skin back and begin cutting the connective tissue all the way down to the bottom of the jaw. When cutting off deer antlers for an antler plaque mount, pay careful attention to the angle of.

Now You Will Center The Antler Over The Correct Pedicle Of The Top Section Of The Skull Plate Form (Make Sure You Are Drilling The Correct Antler Side) And Drill A 3/16” Hole Roughly 1 ¾” Deep Into The Base Of The Antler.

Do as stated above but do this first, get a clean trash can that the rack will fit in , put mounted head , rack down in trash can. There will be a thick, dark membrane left inside. Check on the skull every half hour or so, and cut off anything that has been loosened by the boiling water.

Place The Skull Facing The Blanket.

If your deer is fresh, this is a pretty straight forward. Brush off any dirt, debris, bone dust, and pick off any brain tissue hanging on the base of the antler. Wash as you would a shed in warm water with a dash of dawn in it.

Here Is The Challenging Part, You Have To Cut The Antlers Free Of The Skull To Resemble A Drop.

Begin with the nose of the deer and slowly move up the middle of the snout up to the top of its head. Let the antlers dry completely. Once this had been tested out two holes were drilled in the middle section of the wood.

Place The Deer Skill On A Blanket To Avoid Harming The Delicate Lower Parts Of The Skull While Mounting It.

Using the scalp of the deer sa. Drill two to three small holes through the thickest portion of the top of the skull cap and, ensuring alignment by using a pencil to mark skull hole location on the mounting plaque, directly through the plaque. Let it cool and begin to pick the bits of.